HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM Manuel de référence - Page 26

Parcourez en ligne ou téléchargez le pdf Manuel de référence pour {nom_de_la_catégorie} HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM. HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM 46 pages. 1u rackmount tape enclosure
Également pour HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM : Instructions d'installation (2 pages), Manuel d'instructions d'installation (20 pages), Manuel d'installation (14 pages), Note de mise à jour (14 pages), Instructions d'installation (2 pages)

Completing the installation

Extend the stabilizing feet if provided on your rack.

Extend the left and right rack rails from the front of the rack.

Align the rear of the component rails on the tape enclosure with the front ends of the rack rails,

then slide the unit fully into the rack. See

Figure 21

Slide 1U tape enclosure into rack

CAUTION:

Be sure to keep the enclosure parallel to the floor when sliding the component rails into

the rack rails. Tilting the enclosure up or down could damage the rails.

NOTE:

To remove the enclosure from the rack, disconnect the cables from the back of the unit.

Press the latches on each side

location of the latches.

Tighten the front panel thumbscrews.

If used, retract the stabilizing feet of the rack.

Plug the USB cable from the server into the USB connector(s) on the rear panel of the enclosure.

See

Figure

Rack Installation

F R

O N

and pull the enclosure from the rack

22.

Figure

21.

15111

. See

Figure 21

for the