HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM 참조 매뉴얼 - 페이지 26
{카테고리_이름} HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM 46 페이지. 1u rackmount tape enclosure
HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM에 대해서도 마찬가지입니다: 설치 지침 (2 페이지), 설치 지침 매뉴얼 (20 페이지), 설치 매뉴얼 (14 페이지), 릴리스 노트 (14 페이지), 설치 지침 (2 페이지)
페이지 인쇄
Completing the installation
1.
Extend the stabilizing feet if provided on your rack.
2.
Extend the left and right rack rails from the front of the rack.
3.
Align the rear of the component rails on the tape enclosure with the front ends of the rack rails,
then slide the unit fully into the rack. See
Figure 21
Slide 1U tape enclosure into rack
CAUTION:
Be sure to keep the enclosure parallel to the floor when sliding the component rails into
the rack rails. Tilting the enclosure up or down could damage the rails.
NOTE:
To remove the enclosure from the rack, disconnect the cables from the back of the unit.
Press the latches on each side
location of the latches.
4.
Tighten the front panel thumbscrews.
5.
If used, retract the stabilizing feet of the rack.
6.
Plug the USB cable from the server into the USB connector(s) on the rear panel of the enclosure.
See
Figure
26
Rack Installation
4
3
1
F R
O N
T
and pull the enclosure from the rack
3
22.
Figure
21.
2
15111
. See
Figure 21
for the
4