HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM 설치 지침

{카테고리_이름} HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM 2 페이지. 1u rackmount tape enclosure
HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM에 대해서도 마찬가지입니다: 설치 지침 (2 페이지), 설치 지침 매뉴얼 (20 페이지), 설치 매뉴얼 (14 페이지), 릴리스 노트 (14 페이지), 참조 매뉴얼 (46 페이지)

페이지 인쇄

hp StorageWorks

SDLT external tape drive

Hewlett-Packard Company makes no warranty of any kind with

regard to this material, including, but not limited to, the implied

warranties of merchantability and fitness for a particular purpose.

Hewlett-Packard shall not be liable for errors contained herein or for

incidental or consequential damages in connection with the

furnishing, performance, or use of this material.

This document contains proprietary information, which is protected

by copyright. No part of this document may be photocopied,

reproduced, or translated into another language without the prior

written consent of Hewlett-Packard. The information contained in this

document is subject to change without notice.

All other product names mentioned herein may be trademarks of their

respective companies.

Hewlett-Packard Company shall not be liable for technical or editorial

errors or omissions contained herein. The information is provided "as

is" without warranty of any kind and is subject to change without

notice. The warranties for Hewlett-Packard Company products are set

forth in the express limited warranty statements accompanying such

products. Nothing herein should be construed as constituting an

additional warranty.

SDLT External Tape Drive Installation Instructions

Third Edition (October 2002)

Part Number: 201414-003

installation

instructions

<<bar code goes here in

text box, if applicable>>

201414- 003

The HP SDLT tape drive requires a Wide-Ultra SCSI controller

or higher.

Step 1, Set the SCSI ID (Figure A)

Each SCSI device on the same SCSI bus must have a unique

SCSI ID. The default for HP tape drives is 6. If needed, change

the SCSI ID by pressing the button above or below the number

display on the back of the tape drive enclosure.

Note:

SCSI ID 7 is reserved for the SCSI controller, two SCSI

controllers have IDs 6 and 7.

Step 2, Connect the Cables (Figure B)

1. Turn off the computer and any peripherals.

2. Attach the SCSI signal cable 1 to the SCSI connector 2

located on the rear panel of the SDLT drive and then to the

external SCSI-2 port on the computer. Use the appropriate

SCSI cable for your computer SCSI connection. Two 6-ft

(1.8-m) cables are provided.

3. Attach the terminator (not shown) to the SCSI connector 3.