HP Xw460c - ProLiant - Blade Workstation Manuel d'instructions d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} HP Xw460c - ProLiant - Blade Workstation. HP Xw460c - ProLiant - Blade Workstation 10 pages. Mezzanine card installation instructions for supported hp proliant c-class bladesystem servers
Également pour HP Xw460c - ProLiant - Blade Workstation : Manuel de mise en œuvre (35 pages), Manuel de prévention des erreurs (12 pages), Livre blanc technique (12 pages), Mise à jour du micrologiciel (9 pages), Manuel d'installation (2 pages), Manuel des questions fréquemment posées (14 pages), Poster d'installation (9 pages), Manuel d'installation (33 pages), Manuel de gestion (28 pages), Manuel du matériel (23 pages), Vue d'ensemble (35 pages), Manuel de l'utilisateur (33 pages), Manuel d'optimisation (13 pages), Garantie limitée (10 pages), Manuel d'instructions d'installation (8 pages), Instructions d'installation (4 pages), Instructions d'installation (2 pages)

To remove the graphics board, unscrew the three captive retaining screws as shown below, and unplug the board

from its connector by lifting up.

After removing the graphics board, the blade workstation should appear as shown below. The two connectors that

will be used by the low-profile Quadro FX 560M graphics boards are the Mezzanine 1 and Mezzanine 2

connectors.

Complete the step below based on the specific installation sequence that you're following:

•

Step 4A: Retain the low-profile Quadro FX 560M graphics board that has been removed. Ensure that you

have a second low-profile Quadro FX 560M graphics board available, and continue with Step 5.

•

Step 4B: Set aside the graphics board that has just been removed—this board will not be used further.

Ensure that you have two low-profile Quadro FX 560M graphics boards available, and continue with Step 5.

- 8 -

Mezzanine 2

Mezzanine 1