HP Xw460c - ProLiant - Blade Workstation Handleiding voor installatie-instructies - Pagina 8

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} HP Xw460c - ProLiant - Blade Workstation. HP Xw460c - ProLiant - Blade Workstation 10 pagina's. Mezzanine card installation instructions for supported hp proliant c-class bladesystem servers
Ook voor HP Xw460c - ProLiant - Blade Workstation: Implementatiehandleiding (35 pagina's), Handleiding voor foutpreventie (12 pagina's), Technisch witboek (12 pagina's), Firmware bijwerken (9 pagina's), Installatiehandleiding (2 pagina's), Handleiding met veelgestelde vragen (14 pagina's), Poster opstellen (9 pagina's), Installatiehandleiding (33 pagina's), Management Handleiding (28 pagina's), Hardware Handleiding (23 pagina's), Overzicht (35 pagina's), Gebruikershandleiding (33 pagina's), Handleiding voor optimalisatie (13 pagina's), Beperkte garantie (10 pagina's), Handleiding voor installatie-instructies (8 pagina's), Installatie-instructies (4 pagina's), Installatie-instructies (2 pagina's)

To remove the graphics board, unscrew the three captive retaining screws as shown below, and unplug the board

from its connector by lifting up.

After removing the graphics board, the blade workstation should appear as shown below. The two connectors that

will be used by the low-profile Quadro FX 560M graphics boards are the Mezzanine 1 and Mezzanine 2

connectors.

Complete the step below based on the specific installation sequence that you're following:

•

Step 4A: Retain the low-profile Quadro FX 560M graphics board that has been removed. Ensure that you

have a second low-profile Quadro FX 560M graphics board available, and continue with Step 5.

•

Step 4B: Set aside the graphics board that has just been removed—this board will not be used further.

Ensure that you have two low-profile Quadro FX 560M graphics boards available, and continue with Step 5.

- 8 -

Mezzanine 2

Mezzanine 1