Diamond Way K-Kub Manuel d'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Diamond Way K-Kub. Diamond Way K-Kub 7 pages. Single phase floor grinder

Imprimer la page

Stopping the grinder

1. De-press the red stop button on the starter box.

Safety Precautions

The K-Kub floor grinder has been designed to minimise noise and vibration

levels and to provide maximum safety to the operator. However, incorrect use

of the grinder may cause serious injury to the operator hence the following

precautions must be taken.

1. Do not use the grinder for longer than prescribed in your local

environment working regulations, as the noise load from extensive daily

use may result in hearing defects.

2. Always use protective earplugs or earmuffs, goggles, gloves and

protective footwear.

3. Do not modify the grinder in any manner, or use a machine that has

been modified by anyone other than the manufacturer or authorised

dealers.

4. Do not add weight to the machine to make the grinder work harder.

Instead reduce the number of segments on the grinding plates to

increase the performance.

5. Make sure that re-tipped plates and new grinding plates are balanced

properly.

6. Do not run the grinder with the grinding head raised higher than

necessary, i.e. tipped back on the handle.

7. Always make sure that the folding handle latch is secure and has not

vibrated loose after use.

8. When grinding the machine is exposed to high vibration. Occasionally

check the machine if any nut or bolt has loosened due to the vibration.

9. Do not allow water or cotton to enter the interior of the motor.

Fault Diagnosis

Symptom

Grinder runs for 5 – 15

minutes, then stops

Possible Cause

Motor thermal overload

tripped

Extension cable too long

and/or not made from

Action

Allow to cool, reset

thermal overloads

Then get electrician to

check extension lead

5 |

P a g e