Diamondback 64683 Manuel du propriétaire et consignes de sécurité - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire et consignes de sécurité pour {nom_de_la_catégorie} Diamondback 64683. Diamondback 64683 20 pages. 7" heavy-duty tile saw with sliding table
Imprimer la page
Operating instructions
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tOOL SEt up
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
turn the power Switch of the tool off, remove the Safety Key, and unplug the tool
from its electrical outlet before performing any procedure in this section.
tO prEVEnt SEriOuS inJury:
DO nOt OpEratE WitH any GuarD DiSaBLED, DaMaGED, Or rEMOVED.
installing Blade
1. Unplug the Saw.
2. Turn the Blade Guard Knob counterclockwise.
Open the Blade Guard to expose the Spindle.
3. Press and hold the Spindle Lock in. Loosen the
Spindle Nut counterclockwise and remove the
Nut, Outer Flange, and old Blade, if installed.
4. Leave the Inner Flange on the Spindle,
making sure the cupped side of the Flange
is facing the Tile Saw housing.
5. Wipe a drop of oil onto the Inner Flange
where it will contact the Blade.
WarninG! tO prEVEnt SEriOuS inJury:
Only use a smooth rim, wet cutting, 7" Blade
rated to at least 6000 rpM on this tool.
Do not use a Blade that is too thick to allow Outer
Flange to engage with the flats on the Spindle. Do
not use a Blade that has openings, grooves, or teeth.
6. Slide the Blade (sold separately) onto
Spindle. Make sure that the Blade's rotation
arrow points in the same direction as the
rotation arrow on the Blade Guard
note: The Saw is equipped with two Water
Nozzles to wet the Blade during operation. Make
sure holes in Nozzles face the Blade and that
Blade is positioned between the two Nozzles.
7. Place Outer Flange onto the Spindle.
The flats on the Outer Flange align with the
flats on the Spindle. Install with the cupped
side of the Outer Flange facing the blade.
8. Place Spindle Nut on Spindle. Press and hold
the Spindle Lock in. Wrench-tighten Spindle
Nut securely. Release the Spindle Lock.
9. Close the Blade Guard, and use
the Guard Knob to secure it.
Item 64683
For technical questions, please call 1-888-866-5797.
inner
Spindle
Flange
Lock
Outer
Flange
inner
Flange
Water
nozzle
Blade installation
Spindle
nut
Wrench
Blade
Guard
Blade
Guard
Knob
Spindle
nut
Outer
Flange
Blade
Page 11