Diamondback 64683 Manuel du propriétaire et consignes de sécurité - Page 15
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire et consignes de sécurité pour {nom_de_la_catégorie} Diamondback 64683. Diamondback 64683 20 pages. 7" heavy-duty tile saw with sliding table
Imprimer la page
Maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
turn the power Switch of the tool off, remove the Safety Key, and unplug the tool
from its electrical outlet before performing any procedure in this section.
tO prEVEnt SEriOuS inJury FrOM tOOL FaiLurE:
Do not use damaged equipment. if abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1. BEFOrE EacH uSE, inspect the general
condition of the tool. Check for:
• loose hardware
• misalignment or binding of moving parts
• cracked or broken parts
• damaged electrical wiring
• any other condition that may
affect its safe operation.
2. aFtEr uSE, wipe external surfaces of the tool
with clean cloth. Also, clean the following after
every use, and as needed during extended use:
• Rails
• Water Tray (empty out sediment and water)
• Pump filter and housing
Item 64683
For technical questions, please call 1-888-866-5797.
3. Periodically, wear ANSI-approved
safety goggles and NIOSH-approved
breathing protection and blow dust out of
the motor vents using dry compressed air.
4. If Blade is out of alignment, Table does not
slide smoothly or other issues interfere with
smooth operation, have the Saw serviced by
a qualified technician before further use.
5.
WarninG! if the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
Page 15