Panasonic RX-C52 Manuel d'utilisation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Panasonic RX-C52. Panasonic RX-C52 21 pages. Portable stereo component system

Imprimer la page

SPEAKER

SYSTEM

CONNECTION

This unit can be used as a one-piece portable stereo radio cassette recorder by attaching the speaker system to the main unit, or

as a three-piece separate component system, with a receiver/cassette deck and a separate speaker system, by detaching the

speaker system from the main unit.

sure to set the Power Switch to ''H. OFF" before connecting the Speaker Cables.

m As A One-Piece Portable Radio/Cassette

Recorder

1) Align the speaker with the main unit as shown in the

figure, interlock the grooves, and press down.

2) Remove the Speaker Cables from the Speaker Cable

Compartments at the rear of the speakers, and connect

the plugs to the Speaker Jacks on the main unit.

eWhen using the unit with the speakers attached,

wind the speaker cables as shown.

@ As A Three-Piece Separate Component

System

1) Disconnect the speaker plugs from the Speaker Jacks

on the unit.

2) Pull the Speaker Release

Levers in the direction as

shown in the circles below to unlock them. Then slide the

speakers in the direction of arrow to remove them from

the unit.

Speaker

Release

Lever

Speaker

Release Lever

3) After extending the Speaker Cables, once again connect

their plugs to the Speaker Jacks.

@ Speaker Wall Mounts

1) Drive one screw into the wall for each speaker, as shown

in the figure. Insure that both the screws and the wall can

support a 44 pound (20 kg) load.

2) Mount the speakers to the wall by hanging the Speaker

Wall Mounts (built into the speaker cabinet) onto the

screws.

1%" (3 mm)

less than "e"

(3. mm)

Here"

(5~8 mm)

1%6"~1%6"

(30~40 mm)

wail

Wt;

(7~8 mm)

Re L e

ae ee en eee

OT Rn