bioMetric SpinalPak Manuel complet - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel complet pour {nom_de_la_catégorie} bioMetric SpinalPak. bioMetric SpinalPak 20 pages. Non-invasive spine fusion stimulator system

Imprimer la page

Button Functions

ALARM ON/OFF BUTTON

The Biomet

SpinalPak

charged battery pack is inserted. The button located below the LCD display enables or disables the

audible alarm. During an alarm condition, depressing the button quickly (0.5 seconds) will temporarily

disable the audible alarm. Depressing the button for a longer period of time (3 seconds) will toggle

the audible alarm between enabled and disabled. Patients should be advised to leave the audible alarm

enabled as frequently as possible in order to assure the fully prescribed treatment. A speaker symbol

will be indicated on the LCD display when the alarm is enabled.

LCD Symbol Descriptions and Instructions

The alarm defaults to audible alarm. Press the button below the display on the front of the stimulator

to silence the alarm. After silenced, the light will continue to flash and the display will indicate the

alarm condition.

Symbol

Non-invasive Spine Fusion Stimulator System is activated as soon as a

Condition

Treating

Audible alarm

Low battery charge

Disconnection

System error

Stimulator is

connected to

a PC

End of operation/

Treatment Completion

Instructions

Continue use.

If beeping, depress the button

briefly to silence the alarm. Depress the

button approximately 3 seconds to

engage or disengage the audible alarm.

Insert a charged battery pack.

Confirm that each electrode is properly

applied on the skin. See the electrode

pouch for instructions. Confirm that the

lead wire is attached properly. Replace

the lead wire if necessary.

Error in the stimulator –

Contact Biomet for assistance.

Stimulator will not treat until USB

cable is disconnected

Contact Biomet