Diatip CD 600 Economy Manuel de l'opérateur - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Diatip CD 600 Economy. Diatip CD 600 Economy 13 pages. Retipping system
Midhage Diatip AB
A
Balance
E
D
F
Height adjuster
G
1:st round
slots
block
C
2:nd round
B
7
Loosen the locking lever (A) on the tool.
Lower the cutter head over the edge of
the bit (use the handle (B)) until the
cutting knife (C) is below the worn part of
the barrel and the matrix is inside the
barrel. Make sure that no segment parts
remain where the cut is to be made.
8
Lock the cutter head in position by
turning the lever (A). (The lever is spring
loaded and can be positioned by lifting
the handle from the shaft and then
turning.)
9
Move up the height adjuster (D) close to
the wheel (E) underneath on the cutting
tool and lock the lever (F).
10
Cut the slots for the segments as the
index pin drops into position on the index
plate. Turn the bit clockwise to prevent
unscrewing from the threaded bolt on the
mounting attachment.
11
After the first round, loosen the locking
lever (A) and raise smoothly the cutter
head by lifting up the handle (G) to the
required depth of the notched seats 0 – 5
mm (0" - .197").
Each line on the scale corresponds to
approximately 1 mm.
Lock the cutter head in its new position
with the lever (A) and, this time, cut
between the slots which were cut for the
segments. Cut all the way around and the
top of the core bit can easily be removed.
Now ready for brazing!
Remove the worn part
notched seats
May 2003
6