Diatip CD 600 Economy Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Diatip CD 600 Economy. Diatip CD 600 Economy 13 pagina's. Retipping system

Midhage Diatip AB

Balance

Height adjuster

1:st round

slots

block

2:nd round

Loosen the locking lever (A) on the tool.

Lower the cutter head over the edge of

the bit (use the handle (B)) until the

cutting knife (C) is below the worn part of

the barrel and the matrix is inside the

barrel. Make sure that no segment parts

remain where the cut is to be made.

Lock the cutter head in position by

turning the lever (A). (The lever is spring

loaded and can be positioned by lifting

the handle from the shaft and then

turning.)

Move up the height adjuster (D) close to

the wheel (E) underneath on the cutting

tool and lock the lever (F).

Cut the slots for the segments as the

index pin drops into position on the index

plate. Turn the bit clockwise to prevent

unscrewing from the threaded bolt on the

mounting attachment.

After the first round, loosen the locking

lever (A) and raise smoothly the cutter

head by lifting up the handle (G) to the

required depth of the notched seats 0 – 5

mm (0" - .197").

Each line on the scale corresponds to

approximately 1 mm.

Lock the cutter head in its new position

with the lever (A) and, this time, cut

between the slots which were cut for the

segments. Cut all the way around and the

top of the core bit can easily be removed.

Now ready for brazing!

Remove the worn part

notched seats

May 2003