Dibal G300 Series Manuel de l'utilisateur - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dibal G300 Series. Dibal G300 Series 12 pages.
Imprimer la page
SERIE G300
0 7 9 0
0 7 9 0 8
This indicates the euro phase in which the scales are set:
Phase 1: all sums are calculated in national
currencies, but can also be shown in euros (until
31-12-01).
Phase 2: sums are calculated in euros, but can
also be shown in national currencies ( from 1-1-02
to 28-2-02).
Phase 3: all sums are calculated in euros and
cannot be shown in national currencies ( from 1-3-
02).
To change from phase 1 to phase 2, enter 6 0 2 2,
when the number 2 flashes, repeat the code.
To change from phase 2 to phase 3, enter 9 8 0 8 ,
when wait flashes, repeat the code.
To return to a previous phase, consult your supplier or
technical assistance centre.
4.3
PROGRAMMING OF GRAMS WINDOW
To programme this parameter, enter programming mode
and press
.
This parameter permits programming of a grams
"window" in the weight display, i.e., if the weight varies by
the same or less than the grams window, and the weight
is not stable, the weight will be updated after 2".
If the weight is stable, it will be shown immediately.
4.4
PROGRAMMING OF EAN HEADING
To programme this parameter, enter programming mode
and press 8
This parameter only applies to scales connected to TPV
or POS. To view the parameter, the scales must have
one of the following protocols: PCEAN (7), SANYO (9),
UNIPROX(14), BMC PS-2000 (18), UNIPROX with
checksum(19)
A value between 0 and 99 can be programmed, and this
value will be used as the EAN code heading in protocols
that so require.
8
4.2.4.