Diblasi R7-E Fonctionnement et maintenance - Page 9
Parcourez en ligne ou téléchargez le pdf Fonctionnement et maintenance pour {nom_de_la_catégorie} Diblasi R7-E. Diblasi R7-E 17 pages. Folding motorbike
Imprimer la page
6
To slow down, close the throttle and, if necessary,
apply the brakes.
6
The vehicle is equipped with two brakes. The
front wheel brake is controlled by the lever on
the right side of the handlebar (C-fig 12). The
rear wheel brake is controlled by the lever on the
left side of the handlebar (D-fig.12). Under
normal stopping conditions, use the rear brake
only. Use the front brake only if necessary and in
conjunction with the rear brake: in any case very
softly and with extreme caution. Hard, sudden
use of the front brake can be very dangerous.
6
With the throttle in the closed position, the engine
will run while the vehicle is stationary.
6
To stop the engine:
- In European mopeds: close the throttle and
press the red button (S) located on the left
side of the handlebar (fig.12 EU).
- In USA mopeds: close the throttle and move
the red switch (S), located on the right side of
the handlebar, into STOP position (fig.12 US).
4.5 Lights
The switch for the lights is located on the left side of
the handlebar (L-fig.12)
6
In European mopeds: the three positions of the
switch correspond to: off, low, high beam.
6
In USA mopeds: lights are always switched on
when engine runs. The three positions of the switch
correspond to: low beam, high beam, flashing.
S
D
F
L
E
Fig. 12 EU
F
D
E
L
T
Fig. 12 US
4.6 Horn
The push button for the horn (color blue) is located on
the left side of the handlebar (fig.12 - E).
4.7 Turn signal lamps
The switch (T) for the turn signal lamps is located:
6
In European mopeds: on the right of the
handlebar (fig.12 EU);
6
In USA mopeds: on the left of the handlebar
(fig.12 US);
C
F
G
B
T
C
F
G
B
S