Diblasi R7-E Эксплуатация и обслуживание - Страница 9

Просмотреть онлайн или скачать pdf Эксплуатация и обслуживание для Мотоцикл Diblasi R7-E. Diblasi R7-E 17 страниц. Folding motorbike

To slow down, close the throttle and, if necessary,

apply the brakes.

The vehicle is equipped with two brakes. The

front wheel brake is controlled by the lever on

the right side of the handlebar (C-fig 12). The

rear wheel brake is controlled by the lever on the

left side of the handlebar (D-fig.12). Under

normal stopping conditions, use the rear brake

only. Use the front brake only if necessary and in

conjunction with the rear brake: in any case very

softly and with extreme caution. Hard, sudden

use of the front brake can be very dangerous.

With the throttle in the closed position, the engine

will run while the vehicle is stationary.

To stop the engine:

- In European mopeds: close the throttle and

press the red button (S) located on the left

side of the handlebar (fig.12 EU).

- In USA mopeds: close the throttle and move

the red switch (S), located on the right side of

the handlebar, into STOP position (fig.12 US).

4.5 Lights

The switch for the lights is located on the left side of

the handlebar (L-fig.12)

In European mopeds: the three positions of the

switch correspond to: off, low, high beam.

In USA mopeds: lights are always switched on

when engine runs. The three positions of the switch

correspond to: low beam, high beam, flashing.

Fig. 12 EU

Fig. 12 US

4.6 Horn

The push button for the horn (color blue) is located on

the left side of the handlebar (fig.12 - E).

4.7 Turn signal lamps

The switch (T) for the turn signal lamps is located:

In European mopeds: on the right of the

handlebar (fig.12 EU);

In USA mopeds: on the left of the handlebar

(fig.12 US);