Epever TRACER 6420 Manuel de démarrage rapide

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Epever TRACER 6420. Epever TRACER 6420 8 pages.

Converting the Frequency Plan of a TRACER 6420 System

Introduction

TRACER 6420 systems are shipped from the factory with the frequency plan programmed as Plan A or Plan B.

Each wireless link must contain a Plan A radio on one end and a Plan B on the other. A frequency plan

conversion may be performed in the field, but should only be attempted if absolutely necessary and must

always be performed by qualified personnel. This document outlines the procedure for changing the frequency

plan of a TRACER 6420 system.

This document contains digital images showing connectors, cable routings, etc. Connector

placement and cable routings in the images will not be identical to your TRACER 6420

system. Follow the written procedure provided in this guide and refer to the images only

when instructed.

Prerequisite Procedures

Disconnect all cables attached to the TRACER 6420 system (including power, data,

terminal RS-232, etc.) before performing this procedure.

The current frequency plan configuration is listed on a label located on the rear panel of the unit (near the

Antenna connector). Record the current configuration before beginning this procedure.

Tools and Materials Required

Do not attempt to perform the conversion without the proper tools (see list below). Using

improper tools will damage the unit.

•

5/16" Torque wrench (8 in-lbs)

•

3/16" nut driver

•

Phillips-head screw driver

Electronic equipment can be damaged by static electrical discharge. Before handling

equipment, put on an antistatic discharge wrist strap to prevent damage to components.

Place equipment in antistatic packing material when transporting or storing. When

working on equipment, always place it on an approved antistatic mat that is electrically

grounded.

612806420L1-18A

August 2005