Olympus VANOX Manuel d'instruction - Page 17
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Olympus VANOX. Olympus VANOX 28 pages. Universal research microscope
Imprimer la page
6.
Attach the Observation
Tube.
11
First turn the selector turret on top o f the microscope
s?and
to position
"S".
2)
Check that the two clamping levers on the right hand side of the dovetail
mount are unclarnped (levers pointing upwards).
31
Insert the tube dovetail slide into the dovetail mount on the microscope stand
and lower t h e
tube as
far as possible.
4 )
Lock the tube with the lower clamping lever. {Fig. 9)
*
I f the
tube is used in standard position (selector turret at position "S"), be sure
to clamp the lower clamping lever only.
Fig.
7
Fig. 8
Fig. 9
7 .
Insert Revolving Nosepiece
11
Lower the
stage
as
far as
possible
2)
Unscrew
the
clamping screw
@
of the nosepiece until
it
clears
the
thread
@-
Pull spring-toaded clamping
screw. This
will
cause the
locating pin
@
to withdraw.
(Fig. 10)
3)
With clamp~ng
scrcw ,@
pullcd out, insert
the
nosepiece
into
the ring dovetail
@
on the tube, aligning locating
pin
@
with the locating groove @an ring
dovcta~l. Rclcasc clamping screw @ slowly and the locating pin will drive
home
into the locating groove. Tighten clamping screw
@
(Fig.
11)
*
Locating
groovc
10
and
pin
@ are in alignment i f the nosepiece carrier stays
in place when slightly moved t o the right and left before tightening
knob
.
Fig. 10
Fig. 1 1
8.
Mount the Objectives.
The objectives
are
mounted
in ascending
order of rnagnif ication according to the
engravings A to E on the nosepiece.
9.
Insert the Eyepieces.
Insert a pair of W F l OX eyepieces into the eyepiece tubes of the binocular observation
tube.
Use the
field of
view eyepiece for photomicrography only.
{See page 24.)