Axkid Kidzone Manuel d'instruction - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Axkid Kidzone. Axkid Kidzone 13 pages.

Skip this part

if your car is

equipped with

eyelets

be able to keep its head up on its own, and the

head should not hang forward if the child falls

asleep. The rule of thumb is that the older the

child grows, the more upright the tilt position

can be. Also note that the child seat will be angled

down slightly when it is clamped and sinks into

the car's seat.

Fasten seat belt in the car

Open both belt lock-offs(3) on the child seat.

Grasp the seat belt, and pull the belt roll. The lap

section of the belt should be at least 70-80 centi-

meters (27-32 inch) long.

Now place the belt through the hole in (4)

and push it under the fabric until it comes out on

the other side. If you prefer you can instead pull

the belt on top of the fabric.

Next step is to fasten the seat belt. Tighten

the belt firmly, the belt passing through or over

the seat should not have any slack. Fasten your

belt in belt buckle. In the belt lock-off closest to

the car-buckle both lap and shoulder belt should

be secured. In the belt lock-off on the opposite

side, only the lap belt should be secured.

Your car may have two eyelets in the front seat

rails, or when mounting in the front seat, in front

of the same seat. When your car has no eyelet you

should instead use the supplied strap which is in

the child seat. If the child seat is installed in the

rear seat, put one end of the strap through either

the rear of the front seat rails or another suitable

fastening point in the front seat. The loop should

be as close as possible to the floor. Choose an ap-

propriate length of the strap and then put the

loop through one of the openings on the side of

Continued on next page