Axkid Kidzone Manual de instruções - Página 6
Procurar online ou descarregar pdf Manual de instruções para Assento para automóvel Axkid Kidzone. Axkid Kidzone 13 páginas.
6
4
3
Skip this part
if your car is
equipped with
eyelets
be able to keep its head up on its own, and the
head should not hang forward if the child falls
asleep. The rule of thumb is that the older the
child grows, the more upright the tilt position
can be. Also note that the child seat will be angled
down slightly when it is clamped and sinks into
the car's seat.
Fasten seat belt in the car
Open both belt lock-offs(3) on the child seat.
Grasp the seat belt, and pull the belt roll. The lap
section of the belt should be at least 70-80 centi-
meters (27-32 inch) long.
Now place the belt through the hole in (4)
and push it under the fabric until it comes out on
the other side. If you prefer you can instead pull
the belt on top of the fabric.
Next step is to fasten the seat belt. Tighten
the belt firmly, the belt passing through or over
the seat should not have any slack. Fasten your
belt in belt buckle. In the belt lock-off closest to
the car-buckle both lap and shoulder belt should
be secured. In the belt lock-off on the opposite
side, only the lap belt should be secured.
Attach the tether straps
Your car may have two eyelets in the front seat
rails, or when mounting in the front seat, in front
of the same seat. When your car has no eyelet you
should instead use the supplied strap which is in
the child seat. If the child seat is installed in the
rear seat, put one end of the strap through either
the rear of the front seat rails or another suitable
fastening point in the front seat. The loop should
be as close as possible to the floor. Choose an ap-
propriate length of the strap and then put the
loop through one of the openings on the side of
Continued on next page