Olympus BH-NRE Manuel - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Olympus BH-NRE. Olympus BH-NRE 17 pages. Modular revolving nosepiece

dovetail slide with the four corresponding tapped holes

in the stationary base (see

the dovetail slide such that the relief notch (shown in

the inset of

Figure

37) is facing downwards and towards

the slotted lock ring and pivot-adjustment screw in the

center of the stationary base.

Figure 37 – Position dovetail slide onto stationary base

While holding the dovetail slide in this position on the

stationary base, use a suitable JIS screwdriver to

reinstall four M2.6X5 pan-head screws to secure the

dovetail slide onto the stationary base of the turret

assembly (see

Figure

38).

Figure 38 – Secure dovetail slide onto stationary base

Apply Grease to the Mechanical Detents

Apply fresh grease (item S1 of

mechanical detent notches in the revolving turret (see

Figure

39).

Be careful that you do not get grease

anywhere else.

Complete Teardown, Cleaning, and Reassembly of the Olympus BH-NRE Modular Revolving Nosepiece

Figure

37). Be sure to orient

Appendix

2) to the four

Figure 39 – Apply grease to the four detent notches

Place the protective cover into position on the back side

of the turret assembly, lining up the three holes in the

protective cover with the three tapped holes in the

stationary base (see

Figure

Figure 40 – Place cover in position on the turret assembly

Use a suitable JIS screwdriver to reinstall three M2X3

countersink screws to secure the protective cover onto

the stationary base (see

Figure 41 – Secure protective cover using three screws

40).

Figure

41).

Page 13 of 17

Revision 3