Olympus OMCL-TR800PSA Manuel de l'utilisateur - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Olympus OMCL-TR800PSA. Olympus OMCL-TR800PSA 5 pages. Micro cantilever
Imprimer la page
2) After you set the cantilever strips correctly in the grooves, close the cover and put a piece of the
Scotch drafting tape at the lip of the case to fix it.
3) Once open the cantilever case, level the case with the ground even the case closed (illust. left).
Avoid tilting the case with large angle while handling, or cantilevers may break by scraping with
the stopper pins on the cover if the cantilever strips slide in the case.
The case is always kept even
Avoid tilting the case with large
with ground.
angle while handling
4) Store the cantilevers in a desiccate box for avoiding dust, high temperature and humid even the
case is closed.
7
Storing the cantilever strips in the case for storage
Caution
Be sure to store the cantilevers at room temperature and moderate
humidity.
1) Prepare a case for storing the remaining cantilever strip. (Plastic case for 3.5 inch floppy disk etc.)
2) Keep the cantilever strip in the case for storage as it is taped to the microscope slide glass.
Case for storage
(Plastic case for 3.5 inch floppy disk)
The way to store the rest cantilever strip in the case
3) Attach the microscope slide glass on the case with a Scotch drafting tape.
4) Be sure to give a memo of the product name and lot number on the case for storage.
Incorrect
Cantilever strip
Stopper pins
Microscope slide glass
Rest of cantilever strip
- 9e -
8
Storing the disconnected cantilever chips in the case for storage
1) Store the cantilever chips in another case for storage. If you have a GEL-PAK container, those
chips are easily stored in it.
2) If you don't have a GEL-PAK container, there is a way to arrange a substitute case for chips
storage by yourself. Please refer to the way in the drawing below.
* Like in the drawing below, settle the tape (3) adhesive-side-up on the case with the tape
(1) and (2).
* Using a tape in week adhesiveness as the tape (3) will give you a good result. For
instance, Scotch drafting tape or the adhesive area from a Post-it note is recommended
because the adhesiveness of the tape is appropriate. The use of both side adhesive tapes
that is usual in the office, is not recommendable because most of them is too sticky.
Case for storage
(Plastic case for 3.5 inch floppy disk)
Tape (1)
The way to store the cantilever chips in the case
3) Be sure to give a memo of the product name and lot number on the case for storage.
9
Information
Please contact following if you have any question on this user's manual.
OLYMPUS CORPORATION
Microtechnology R&D Division
2-3 Kuboyama-cho Hachioji-shi Tokyo 192-8512 Japan
email : [email protected]
Please access to the web page of OLYMPUS micro cantilevers.
http://www.olympus.co.jp/probe
Tape (3) (adhesive side up)
Tape (2)
Cantilever chip
Ver. 5.0 August 6, 2009
OLYMPUS CORPORATION
- 10e -