Olympus OMCL-TR800PSA Manuel de l'utilisateur - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Olympus OMCL-TR800PSA. Olympus OMCL-TR800PSA 5 pages. Micro cantilever
Imprimer la page
2) Turn the microscope slide glass sideway for disconnecting a chip (see below).
Then, cantilevers on a chip end face to you (see right below).
Cantilever chip
Microscope slide glass
Cantilever strip
3) Hold the center of the cantilever chip with the tweezers to cut a chip at the end of the cantilever
strip. Place a scalpel (or razor blade) at the connecting part between the cantilever chips, and
scribe a chip off gently.
Tweezers
Razor blade
Chip substrate
Put the scalpel to the edge of connecting part, push the scalpel and give pressure to the
edge with it like in the drawing above. The side face of the scalpel should be kept
parallel to the side wall of the groove for making this procedure easy.
Connecting part
Scalpel or razor blade
(Groove)
Cantilever chip
Connecting part
(Groove)
Putting the scalpel parallel to connecting
part is recommended.
Cantilever
Cantilever
Connecting part (Groove)
Tape
Razor blade
Tweezers
Connecting part (Groove)
It may be better to press your forefinger on t
scalpel (above) to apply vertical pressure to
the connection.
- 7e -
5
Attaching the cantilever chip to your instrument
1) After reading the instruction manual of your instrument again, grasp the side of the cantilever
chip with the tweezers and attach the cantilever chip to your scanning probe microscope.
Cantilever chip substrate
Tweezers
6
Returning the cantilever strips into the plastic case
Lay the cantilever strip correctly in the grooves of the bottom cover
when you return the cantilever strips into the plastic case for
transportation again.
Do not drop or shake the cantilever case. Even when the cantilever strips
are contained in the cantilever case, the cantilever strips may move in the
case and the cantilever may break if the case is handled roughly or jarred.
1) Once you take out a cantilever strip from the case for transportation, storing the cantilever strip
in a separate case is recommended. The way will be explained in the next head (8) in this
manual. Although it is possible to store the cantilever strip in the case for transportation, please
pay attention to the following.
* Please avoid storing plural cantilever strips with different lot number in a case.
* Please pay attention to the position
and the direction of the grooves
where cantilever strips should be
placed on. Be carefully to lay the
cantilever strips parallel to/in the
grooves of the bottom cover. (see
right)
* If you place the cantilever on the
bottom case incorrectly, cantilevers
he
and cantilever strips may break
when you close the case.
Tape
Caution
Caution
Hold position
Laying cantilever in a groove of the bottom cover
- 8e -
Groove