Axminster MCB100A Manuel de l'utilisateur - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Axminster MCB100A. Axminster MCB100A 20 pages. 4" metal cutting bandsaw
Imprimer la page
VERTICAL CUTTING
1. Fasten the supporting bar (A) in Fig. 6
into the slot at the saw head.
2. Raise saw head to vertical position by
lifting up the knob (B) a little to release
the lock-pin and slide it into the slot which
is set for 90 degree.
3. Remove the small plate (C).
4. Before cutting a bigger work, take away
the carrying handle (E). After service,
replace the handle.
Caution:
Be sure that the machine is
disconnected from the power source
before attempting to service or take
any component away!
MAGNETIC SWITCH
The band saw is equipped with TRIPUS
magnetic switch which is designed for
operating safety. After power failure, the
machine has to be restarted by opening the
cover and pushing the inner " ON " button.
There is a red button attached on the switch
cover, depress it to stop all machine functions
if emergency. This magnetic switch also
connects with the limit switch at the back of
bed, when the work piece is completely cut,
both switches will shut off automatically.
Fig. 6
MAGETIC SWITCH