Axminster ZQJ4125K Manuel - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Axminster ZQJ4125K. Axminster ZQJ4125K 18 pages.

WORKING CLEARANCES

Working clearances can be thought of as the distances between machines and obstacles

that allow safe operation of every machine without limitation. Consider existing and

anticipated machine needs, size of material to be processed through each machine, and

space for auxiliary stands and/or work tables. Also consider the relative position of each

machine to one another for efficient material handling. Be sure to allow yourself sufficient

room to safely run your machines in any foreseeable operation.

LIGHTING AND OUTLETS

Lighting should be bright enough to eliminate shadow and prevent eye strain. Electrical

circuits should be dedicated or large enough to handle combined motor amp loads. Outlets

should be located near each machine so power or extension cords are not obstructing

high-traffic areas. Be sure to observe local electrical codes for proper installation of new

lighting, outlets, or circuits.

3: ASSEMBLY

Most of your Drill Press has been assembled at the factory, but some parts must be

assembled or installed after delivery. We have organized the assembly process into steps.

Please follow along in the order presented here.

Drill press must be secured to the floor using anchor bolts, or the base should be secured

to a piece of plywood.

1. Unplug machine before assembly.

2. Secure the base to the floor using the appropriate anchor bolts.

3. Place the column on the base and line up the mounting holes. Insert and tighten the

M10-1.5 hex head bolts with a wrench.

Table Support

1. Thread the 12mm table lock handle 3 turns into the table support bracket as shown in

Figure 3.

2. Insert the pinion gear into the hole on the side of the table support bracket from the

inside, starting with the pinion shaft as shown in Figure 3. Align setscrew in crank

handle with flat on pinion gear shaft and secure using the 3mm Allen

as shown in Figure 4.

3. Examine the rack and note that the gear teeth extend farther on one end than the other.

The end of the rack where the gear teeth are closest to the end should be positioned

down. Insert the rack into the table support bracket and align it with the pocket as

shown in Figure 4. The gear teeth on the rack must also face out.

We reserve the right of the amendment addition and deletion of the

specifications, explanatory wording, etc. printed in this manual

PDF 文件使用 "pdfFactory Pro" 试用版本创建

DRILL PRESS MANUAL

www.fineprint.cn

wrench provided