Axminster ZQJ4125K Manuel - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Axminster ZQJ4125K. Axminster ZQJ4125K 18 pages.

4. Slide the table support bracket onto the column while holding the rack in place. Allow

the bracket to go down until the bottom of the rack contacts the shoulder on the column

support as shown in Figure 4. Secure the table support bracket with the lock handle.

5. Slide the column ring onto the column with the inside bevel in the down position as

shown in Figure 5. Adjust the ring until the tip of the rack fits inside the bevel. Tighten

the setscrew on the ring.

Headstock

1. There is a pocket in the bottom of the headstock for the column to be placed. Seek

assistance to help position the headstock over the column. Allow the headstock to slide

down until it stops (approximately 4").

2. Position the headstock directly over the base by using a plumb bob. Use a measuring

tape or ruler across the drill press base to find its center. Suspend the plumb line from

the center of the headstock label and lower the bob until it is near the tape/ruler as

shown in Figure 6. Adjust headstock from side to side until the tip is equidistant from

both the left and right sides.

3. Tighten the two head Locking screws shown in Figure 7 to secure headstock to the

We reserve the right of the amendment addition and deletion of the

specifications, explanatory wording, etc. printed in this manual

PDF 文件使用 "pdfFactory Pro" 试用版本创建

DRILL PRESS MANUAL

Figure 3

Figure5

www.fineprint.cn

Figure 4

Figure6