Alphalite ILT-SMK-22 Instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Alphalite ILT-SMK-22. Alphalite ILT-SMK-22 3 pages. Surface mount kit

Imprimer la page
Installation Instructions
Surface Mount Kit
1. Using the appropriate dimensions and fasteners
the surface mount kit to junction box and loosely
secure the surface mount frame to the ceiling. Ensure
the frame is square prior to fully securing the frame
to the ceiling. Slots will allow for adjustment once the
frame is attached.
Safety Cable
3. Prior to wiring fixture, secure safety cables at
each end of the fixture by at tacking to the existing
protruding screws and secure with #10-32 nuts.
10715 Springdale Ave, Ste 4, Santa Fe Springs, CA 90670
Safety Cable
J-Box
Appropriate fasteners
for ceiling type x4
l
2. Secure end plate to one side of surface mount
frame by securing clips to frame edge and rotating
slots into studs on frame. Secure using two #10-32
nuts.
4. Make all electrical connections according to local
code and make sure safety cables are secure. Angle
the fixture into the bottom flange of the surface mount
kit between locating tabs on all four corners. If the
fixture is not resting properly on the bottom flange, lift
it up and shift it until it rests into place.
Tel: 1-888-287-9228
Fax: 1-888-258-9183
l
Secure end plate
with two #10-32 nuts
l
2