Alphalite ILT-SMK-22 Instrukcje instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Stojaki i stojaki Alphalite ILT-SMK-22. Alphalite ILT-SMK-22 3 stron. Surface mount kit

Installation Instructions

Surface Mount Kit

1. Using the appropriate dimensions and fasteners

the surface mount kit to junction box and loosely

secure the surface mount frame to the ceiling. Ensure

the frame is square prior to fully securing the frame

to the ceiling. Slots will allow for adjustment once the

frame is attached.

Safety Cable

3. Prior to wiring fixture, secure safety cables at

each end of the fixture by at tacking to the existing

protruding screws and secure with #10-32 nuts.

10715 Springdale Ave, Ste 4, Santa Fe Springs, CA 90670

Safety Cable

J-Box

Appropriate fasteners

for ceiling type x4

2. Secure end plate to one side of surface mount

frame by securing clips to frame edge and rotating

slots into studs on frame. Secure using two #10-32

nuts.

4. Make all electrical connections according to local

code and make sure safety cables are secure. Angle

the fixture into the bottom flange of the surface mount

kit between locating tabs on all four corners. If the

fixture is not resting properly on the bottom flange, lift

it up and shift it until it rests into place.

Tel: 1-888-287-9228

Fax: 1-888-258-9183

Secure end plate

with two #10-32 nuts