Arcam FMJ P35 Manuel - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Arcam FMJ P35. Arcam FMJ P35 16 pages. Amplifiers
Également pour Arcam FMJ P35 : Manuel de l'utilisateur (8 pages), Manuel d'entretien (18 pages)

Imprimer la page

Installation: A32 integrated ampliﬁ er

VOLTAGE

SELECT

POWER INLET

115/230V

POSITIONING THE UNIT

Place your amplifier on a level, firm surface.

Avoid placing the unit in direct sunlight or near sources of heat or

damp.

Ensure adequate ventilation. Do not place the unit in an enclosed

space such as a bookcase or cabinet as both of these will impede air

flow through the ventilation slots.

CONNECTING TO LOUDSPEAKERS

You can connect one or two pairs of loudspeakers to your amplifier,

provided each pair is rated between 8–16 . If one or both pairs have

an impedance of less than 8 , the combined load on the amplifier falls

below 4

and could cause an overload. If so, the overload protection

circuit engages and the amplifier will not work.

To connect one pair of loudspeakers, use the

SP1 and SP2 terminals

Both sets of loudspeaker terminals can be switched off by pressing the

button on the remote control. To switch

MUTE

use the front panel switch

page 10).

Your amplifier is fitted with loudspeaker terminals to BFA (British

Federation of Audio) standard specification.

BFA loudspeaker terminals

The terminal will accept spade terminals, bare wires or a BFA plug.

BFA plugs are available from your Arcam dealer. To connect a bare wire

or spade terminal, unscrew the red (or black) part of the loudspeaker

terminal first.

Insert the wire or spade terminal and screw it back up.

CAUTION: Do not over tighten the loudspeaker terminals or use

a wrench, pliers, etc., as this could cause damage to the terminals

which will not be covered under warranty.

SP2

4 – 16 OHMS

TRIG

OUT

SP1

REMOTE

–

terminals.

SP1

and

independently,

SP1

SP2

(see page 7) or the remote control (see

INTEGRATED

–

PRE/PWR

PWR IN

PRE OUT

Right

speaker

Connect the right speaker to the terminals on the back of your

amplifier marked

Connect your loudspeakers so that the red (positive/+) terminal on

each loudspeaker is connected to the red (positive/+) terminal on the

amplifier. Your loudspeaker cables may be marked to show polarity

(negative/– and positive/+), if not, then the positive terminal can usually

be identified by a ridge or coloured marking.

Now connect your loudspeakers' black (negative/–) terminals to the

black (negative/–) terminals on the amplifier.

Ensure that no stray strands of inner wires are allowed to touch

another cable or the amplifier's casing. This can cause a short circuit

and damage your amplifier!

RECORD

PLAY

OUT

TAPE/PROC

VCR/TAPE 2

DVD

8 9 bk bl bm bn bo bp

Arcam A32 amplifier

–

Wiring your loudspeakers

and the left speaker to the terminals marked

PHONO

TUNER

AUX

–

Left

speaker