Arcam FMJ P35 Manuale - Pagina 5
Sfoglia online o scarica il pdf Manuale per Amplificatore Arcam FMJ P35. Arcam FMJ P35 16. Amplifiers
Anche per Arcam FMJ P35: Manuale d'uso (8 pagine), Manuale di servizio (18 pagine)
Installation: A32 integrated amplifi er
VOLTAGE
SELECT
POWER INLET
115/230V
1
2
POSITIONING THE UNIT
Place your amplifier on a level, firm surface.
Avoid placing the unit in direct sunlight or near sources of heat or
damp.
Ensure adequate ventilation. Do not place the unit in an enclosed
space such as a bookcase or cabinet as both of these will impede air
flow through the ventilation slots.
CONNECTING TO LOUDSPEAKERS
You can connect one or two pairs of loudspeakers to your amplifier,
provided each pair is rated between 8–16 . If one or both pairs have
an impedance of less than 8 , the combined load on the amplifier falls
below 4
and could cause an overload. If so, the overload protection
circuit engages and the amplifier will not work.
To connect one pair of loudspeakers, use the
4
SP1 and SP2 terminals
Both sets of loudspeaker terminals can be switched off by pressing the
button on the remote control. To switch
MUTE
7
use the front panel switch
page 10).
Your amplifier is fitted with loudspeaker terminals to BFA (British
Federation of Audio) standard specification.
BFA loudspeaker terminals
The terminal will accept spade terminals, bare wires or a BFA plug.
BFA plugs are available from your Arcam dealer. To connect a bare wire
or spade terminal, unscrew the red (or black) part of the loudspeaker
terminal first.
Insert the wire or spade terminal and screw it back up.
CAUTION: Do not over tighten the loudspeaker terminals or use
a wrench, pliers, etc., as this could cause damage to the terminals
which will not be covered under warranty.
SP2
4 – 16 OHMS
TRIG
OUT
SP1
REMOTE
IN
+
–
R
3
4
terminals.
SP1
and
independently,
SP1
SP2
(see page 7) or the remote control (see
L
INTEGRATED
R
+
–
L
PRE/PWR
PWR IN
PRE OUT
5
6
7
Right
speaker
Connect the right speaker to the terminals on the back of your
amplifier marked
Connect your loudspeakers so that the red (positive/+) terminal on
each loudspeaker is connected to the red (positive/+) terminal on the
amplifier. Your loudspeaker cables may be marked to show polarity
(negative/– and positive/+), if not, then the positive terminal can usually
be identified by a ridge or coloured marking.
Now connect your loudspeakers' black (negative/–) terminals to the
black (negative/–) terminals on the amplifier.
Ensure that no stray strands of inner wires are allowed to touch
another cable or the amplifier's casing. This can cause a short circuit
and damage your amplifier!
5
L
R
RECORD
RECORD
PLAY
PLAY
OUT
IN
OUT
IN
TAPE/PROC
VCR/TAPE 2
DVD
AV
8 9 bk bl bm bn bo bp
Arcam A32 amplifier
+
–
+
R
–
+
+
Wiring your loudspeakers
and the left speaker to the terminals marked
R
L
PHONO
R
MM
MC
TUNER
CD
AUX
bq
br
–
L
–
Left
speaker
.
L