AXTON CAC2.6ES Manuel d'installation - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AXTON CAC2.6ES. AXTON CAC2.6ES 17 pages.

TWEETER INSTALLATION

There are three ways to install the CAT29 tweeters: Normal ﬂat, angled surface or fully

recessed mounting.

Flat Surface Mounting

The tweeter system consists of three parts: The main tweeter unit, the backside of the

housing adapter and the front ring (chromed).

■ Mark the location where you are going to mount the tweeters. Drill three holes on each

side, one main hole with a bigger diameter for the wire and two small pilot holes for the

two screws ﬁxing the tweeter housing to the mounting surface.

■ Mount the adapter cup with two ﬂathead screws.

■ Feed the wire of the tweeter through the hole and connect it to the wire extension that

goes to the crossover. Align the chromed front ring over the the tweeter main housing,

push it down and turn the ring clockwise to ﬁx it in place (bayonet design).

Angled Surface Mounting

■ Apply the same procedure as described above, but use the angled mounting adapter

rear cup.

Flush Mounting

After choosing the best mounting location, make sure there is at least 25 mm of clearance

behind the mounting surface (for the tweeter cross-spring!), before you start to mark or cut

anything!

Cut a hole with exactly 52 mm diameter into the mounting surface using a power drill and

a circle cutter tool.

Secure the ﬂush mount tweeter adapter in the cutout with the metal cross blade and

the two machine screws provided in the mounting accessory kit. Push the main tweeter

down into the rear cup with the chromed front ring, turn clockwise to lock it. Feed the wire

through the center hole of the cup and attach the wire to the extension cable that goes to

the crossover.

CROSSOVER WIRING & MOUNTING

The crossover can be mounted in almost any location inside the vehicle. Recommended

places are: Inside the door, under the carpet in front of the door angles, under the dash-

board a.s.o. Just make sure not to install the crossover units, where they may be exposed

to dirt or excessive moisture / water.

Connect the tweeter wires, the wires from the mid/woofers and the main wires coming

from the ampliﬁer to the crossover. Maintain polarities all the way – double check for cor-

rect connection. It is very important to make sure that all the connections are electrically in

phase, which means positive wire (+ or red) is connected to positive terminal, and negative

wire (-black) is connected to the negative terminal.

Reverse polarity connections, i.e. when a mid/woofer is concerned, will cause a very low

bass output and a messed up front staging.

If longer distances from the ampliﬁer to the crossovers have to be overcome, use good

quality speaker cables with a minimum cross section of 2.5mm². Failure to do so will affect

sound quality in a negative way.

– 11 –