AXTON CAC2.6ES Manuel d'installation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} AXTON CAC2.6ES. AXTON CAC2.6ES 17 pages.

MOUNTING THE MID/WOOFERS

Remove the factory grilles of the door - or if necessary - the complete door panels. The

13 / 16.5 cm EURO-DIN frame mid/woofer units provide bolt and screw holes to ﬁt a great

variety of OEM standard patterns, making them ideal for a direct replacement of factory

installed speakers in European or Asian cars.

■ Remove the factory installed mid/woofers or fullrange speakers. Before you attempt to

install the new AXTON mid/woofers, you must check the available installation depth of

the left and right front doors. To do this, slide down both windows and hold the AXTON

mid/woofers in place to reassure the available installation depth does sufﬁce. This test is

important, failure to do this may let you end up with an impaired window function!

■ Look out for a good location to mount the crossovers. Consider that the x-overs should

remain accessible for several adjustments after the installation of the speakers is comple-

ted. Potential places to mount your x-overs are under the dashboard, inside the doors,

a.s.o.

■ Connect the corresponding speaker wires to the blade connector terminals of the mid /

woofer units. Route these wires to the location, that was chosen to install the crossovers

later on.

■ Check that there are no gaps between the speakers and the mounting surface in the

doors. Note that some (newer) cars will require the use of car-speciﬁc mounting adapters

made of pastic injection material. Without them, some Euro-DIN mid/woofers will not ﬁt to

the OEM cutout, or the available installation depth will not be sufﬁcient. Such adapters are

usually available from your authorized AXTON dealer.

■ The cone and surround material of the mid / woofers is 100% water proof. However a

direct exposure of the mid / woofer to water inside the doors should be avoided. In most

cases, protection foils are pre-installed to protect the OEM full-range speaker. Do not rip

this foil out of the doors, it is there for a good purpose!

■ Fix the mid/woofer to the speaker mounting hole using the provided screws. If the mid/

woofers are directly screwed onto the sheetmetal of the door, use the metal clips included

with the mounting hardware. You can now reinstall the factory plastic grilles, but make

sure the surrounds of the mid/woofers do not come in touch with plastic parts standing

off on the backside of the grilles.

■ In case you have chosen a new location for your mid/woofers (other than factory cut-

out), use the speaker protection grilles as follows: Mount the mid/woofer onto the plastic

trim ring using the screws and the metal clips. Fit the metal-grille into the trim ring and

if needed, for a better and more durable ﬁxation of the metal mesh grille, use the black

„chewing gum" pieces.

– 9 –