Axxess AX-DSPX-WR Manuel d'instructions d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Axxess AX-DSPX-WR. Axxess AX-DSPX-WR 20 pages. Axxess 10-channel digital signal processor with water resistant case
Imprimer la page
1. With the arrow stamped onto the cap facing upwards, push the 16-pin connector from the
AX-DSPX-WR harness into the left side of the cap. The locking clip on the connector should
face upward. Make sure the gasket is seating properly in the cap. (Figure A)
2. With the arrow stamped onto the cap still facing upwards, push the 20-pin connector from
the AX-DSPX-WR harness into the right side of the cap. The locking clip on the connector
should face upward. Make sure the gasket is seating properly in the cap. (Figure A)
3. Plug the 16-pin and 20-pin connectors from the AX-DSPX-WR harness into the
AX-DSPX-X circuit board. (Figure A)
4. Slide the assembly into the case, then click it shut. Zip-tie the enclosure to a secure location
to secure it. Make sure the Axxess logo is facing up to further ensure that no outside elements
can enter the enclosure.
5. Complete all necessary connections to the radio and vehicle, but leave the amp turn-on wire
disconnected.
6. Download and install the AX-DSP-X app from the Google Play Store or Apple App Store.
7. Open the app and follow the instructions on the Bluetooth Connection tab to pair the mobile
device to the AX-DSPX-WR.
8. Scroll to the Configuration tab then select General as the vehicle type.
9. Connect the amp turn-on wire from the AX-DSPX-WR.
10. Adjust the DSP settings in the app as desired. Refer to the instructions starting on (page 7)
for an explanation of each tab in the app.
(refer to page 7)
INSTALLATION
AX-DSP-X
Circuit Board
Cap (with O-ring)
AX-DSPX-WR
Harness
(Figure A)
Case
16-Pin
20-Pin
Gasket
REV. 10/14/2019 INSTAX-DSP-X
Zip-tie Mounts
3