digigate slider ROBO 24 Manuel - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} digigate slider ROBO 24. digigate slider ROBO 24 7 pages. Sliding gate operator

Imprimer la page

Height adjustment

For the height adjustment to be possible, the four adjusting screws

provided in the small accessory box must be fitted as in fig. 9 on page 7, before

mounting the machine to the steel base plate. Ideally, these screws should protrude 5 to

10 mm, creating a gap between the base plate and the under side of the machine. This

will allow for subsequent height adjustment.

Wiring For all connections refer to Fig. 1.

Mains.

A suitable cable (armoured 3-core or Surfex) should be used from a 2-

circuit breaker on the distribution board to the site of the motor, where it is

brought up through the opening in the base plate. See page 5 Fig. 4. Connect

the earth wire and the armour to the spare lug provided on the chassis earthing

point. Connect the Line and Neutral wires to the terminals 'L' and 'N' on the

controller, shown as '230V MAINS' in Fig. 1.

L N N L

+ - + -

LAMP

BATTERY MOTOR

MAINS

230V~

Accessories.

Before connecting any accessories, decide which 'Type' of operating mode will be

used, 'Standard' or 'Commercial'. 'Standard' is suitable for residential purposes, giving

each user full control of the gate. 'Commercial' avoids conflicting inputs by providing a

dedicated 'Open' input for the users. Separate 'Stop' and 'Close' connections are also

provided.

Note: All the accessories are referenced to '0V-COM'.

N.C. and N.O. refer to switch contacts, and stand for 'Normally Closed' and

'Normally Open'.

Partial. For pedestrian use, a key Switch may be connected to 'Partial'.

This switch will cause the gate to open to a width of about 1,2m. Once partially opened,

the gate may be re-closed using the same switch, or it will auto-close in the time

selected (5, 10 or 20 seconds) or in 5 seconds if Auto-close is not selected.

If the gate is closing after being partially opened and the safety beam is blocked, the

gate will only re-open to the partially open point.

PROGRAM DISPLAY

PLUGGABLE MEMORY

ENTER BUTTON

SELECT BUTTON

STANDARD

PARTIAL

CONTROL

LOCK

ON/

LIGHT

OFF

0V-COM

BEAM N.C.

BEAM 24V+ BEAM 24V+

GATE

STATUS LED+

ANTENNA

0V-COM

MANUAL

ENCODER

Fig. 1

24V DC

TYPE

COMMERCIAL

PARTIAL

OPEN

STOP

0V-COM

BEAM N.C.

GATE

STATUS LED+

amp