Digilock NEXT cue Manuel du produit - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel du produit pour {nom_de_la_catégorie} Digilock NEXT cue. Digilock NEXT cue 6 pages. Rfid interface bolt mechanism
Également pour Digilock NEXT cue : Manuel du produit (5 pages), Manuel d'installation (16 pages)

Imprimer la page
Digilock NEXT cue Manuel du produit
Programming Instructions
Add Manager Keys and RFID Credentials
Manager Credentials can be programmed to the locks at any time.
1
Go to a lock requiring additional
Manager Credentials.
Press and hold
`
for 5 seconds (a
two-tone beep will be heard after 5
seconds) then release.
The LED will turn on.
Replace Keys
Replacement keys must be purchased and programmed to the locks to prevent the lost/stolen keys from operating a lock.
1
To replace the Programming Key:
Note the order or serial number (found on the lock's rear unit).
1a
To replace the Manager Keys:
Collect all remaining Manager Keys.
Go to any lock operated by the lost/stolen manager keys. Press and
hold
for 5 seconds (a two-tone beep will be heard after 5 seconds)
`
then release.
The LED will turn on.
Product Guide
2
While the LED is on, insert the
Programming Key.
A two-tone beep will be heard.
1b
RFID Interface
Latch Mechanism
Assigned Use Functionality
3
Insert each additional Manager
Key or present each Manager
RFID Credential one at a time.
A two-tone beep will be heard for
each Manager Key or Manager
RFID Credential programmed.
2
Contact Digilock Support to purchase a replacement Programming Key.
2a
While the LED is on, insert the Programming Key.
A two-tone beep will be heard and the LED will remain on.
Insert the Programming Key again.
Three sets of two-tone beeps will be heard and the LED will turn off. All
previously programmed Manager Keys and Manager RFID Credential
are erased.
Follow instructions to Add Manager Keys and RFID Credentials to
program the intended Manager Credentials to the locks.
4
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
Repeat above steps for each lock
or follow instructions to Express
Register Manager Credentials
to program the same Manager
Credentials to multiple locks.
2b
3