Cisco 2960-C Manuel de démarrage - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco 2960-C. Cisco 2960-C 25 pages.
Également pour Cisco 2960-C : Manuel d'installation (37 pages)

Imprimer la page

Running Express Setup

Note

Step 1

Make sure that nothing is connected to the switch.

During Express Setup, the switch acts as a DHCP server. If your PC has a static IP address,

temporarily configure your PC settings to use DHCP before going to the next step.

Write down the static IP address. You will need this IP address in

Note

Step 2

Power the switch:

For switch models with an AC power connector

•

Plug the AC power cord into the AC power connector and into an AC power outlet.

For switch models with an AUX power connector

Connect a 10/100/1000 uplink port to a PoE switch, such as a Catalyst 3750-X.

•

Plug the auxiliary power adapter cord into the AUX power connector and into an AC

•

power outlet.

For more information on powering the switches, see the "Switch Installation" chapter

Note

in the hardware guide.

Catalyst 3560-C and 2960-C Switch Getting Started Guide

You should use Express Setup to enter the initial IP information. You can then

access the switch through the IP address for further configuration.

To use the CLI-based initial setup program, see Appendix C, "Configuring the

Switch with the CLI Setup Program," in the switch hardware guide.

You need this equipment:

PC with Windows 2000, XP, Vista, or Windows Server 2003

•

Web browser (Internet Explorer 6.0, 7.0, or Firefox 1.5, 2.0, or later) with

•

JavaScript enabled

Straight-through or crossover Category 5 or 6 cable

•

Before running Express Setup, disable any pop-up blockers or proxy settings on

your browser and any wireless client running on your PC.

Catalyst 3560-C and 2960-C Switch Getting Started Guide

Step

10.

OL-23802-02