Cisco 2960-C Podręcznik dla początkujących - Strona 4
Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla Przełącznik Cisco 2960-C. Cisco 2960-C 25 stron.
Również dla Cisco 2960-C: Instrukcja instalacji (37 strony)
Drukuj stronę
Running Express Setup
Note
Note
.
Step 1
Make sure that nothing is connected to the switch.
During Express Setup, the switch acts as a DHCP server. If your PC has a static IP address,
temporarily configure your PC settings to use DHCP before going to the next step.
Write down the static IP address. You will need this IP address in
Note
Step 2
Power the switch:
For switch models with an AC power connector
•
Plug the AC power cord into the AC power connector and into an AC power outlet.
For switch models with an AUX power connector
Connect a 10/100/1000 uplink port to a PoE switch, such as a Catalyst 3750-X.
•
Or
Plug the auxiliary power adapter cord into the AUX power connector and into an AC
•
power outlet.
For more information on powering the switches, see the "Switch Installation" chapter
Note
in the hardware guide.
Catalyst 3560-C and 2960-C Switch Getting Started Guide
4
You should use Express Setup to enter the initial IP information. You can then
access the switch through the IP address for further configuration.
To use the CLI-based initial setup program, see Appendix C, "Configuring the
Switch with the CLI Setup Program," in the switch hardware guide.
You need this equipment:
PC with Windows 2000, XP, Vista, or Windows Server 2003
•
Web browser (Internet Explorer 6.0, 7.0, or Firefox 1.5, 2.0, or later) with
•
JavaScript enabled
Straight-through or crossover Category 5 or 6 cable
•
Before running Express Setup, disable any pop-up blockers or proxy settings on
your browser and any wireless client running on your PC.
Catalyst 3560-C and 2960-C Switch Getting Started Guide
Step
10.
OL-23802-02