Cisco 9124 - mds multilayer fabric switch Note de mise à jour - Page 15

Parcourez en ligne ou téléchargez le pdf Note de mise à jour pour {nom_de_la_catégorie} Cisco 9124 - mds multilayer fabric switch. Cisco 9124 - mds multilayer fabric switch 22 pages. Mds 9000 series
Également pour Cisco 9124 - mds multilayer fabric switch : Spécifications (2 pages), Fiche technique (9 pages), Spécifications (3 pages), Manuel de configuration (49 pages), Note de mise à jour (48 pages), Note de mise à jour (44 pages), Note de mise à jour (36 pages), Note de mise à jour (3 pages), Note de mise à jour (40 pages), Manuel (16 pages), Manuel d'installation du matériel (36 pages)

FC AND FCIP WRITE ACCELERATION FEATURE MUST NOT BE

ENABLED WHEN IMPLEMENTING CONTINUOUS ACCESS

ENTERPRISE VIRTUAL ARRAY

Continuous Access Enterprise Virtual Array includes an FC/FCIP write acceleration feature. For

this reason, Cisco's FC and FCIP write acceleration must not be enabled in a Continuous Access

EVA environment. By default Cisco SAN-OS write acceleration is disabled.

FCIP TAPE ACCELERATION

SAN-OS FCIP Tape Acceleration (Write & Read) is disabled by default. Enabling FCIP Tape

Acceleration may cause a tape library to go offline with certain tape backup applications that

support shared tape library options. If this issue is encountered, disable the feature.

Note: FCIP Tape Read Acceleration can only be enabled when both ends of the FCIP tunnel are

running SAN-OS 3.0(1) or newer

SWITCH SETTINGS FOR HP CONTINUOUS ACCESS

ENTERPRISE VIRTUAL ARRAYS AND HP DATA REPLICATION

MANAGER FOR MODULAR ARRAYS

The default load balancing policy for SAN-OS is Src-ID/Dst-ID/OX-ID. This must be changed

when using Enterprise Virtual Array families or Modular Array families configured for

Continuous Access EVA and/or Data Replication Manager (DRM). Change the default load

balance setting to Src-ID/Dst-ID using either one of the following two procedures:

Note: The MDS 9020 only supports Src-ID/Dst-ID.

Using the Management Console or Telnet to Change the Load Balancing Setting

Use the following procedure to change the load balance setting to Src-ID/Dst-ID with

management console or telnet:

Note: Your login account must have network-admin privileges to complete this procedure.

1. Log into the switch using either the management console or telnet.

2. Enter your network-admin privileged account by entering your login name and password.

switch login: admin

Password: <admin password>

3. Enter the following to enter configuration mode:

MDS Multilayer Director & Multilayer Fabric Switches Release Notes