Cisco 9124 - mds multilayer fabric switch Примечание к выпуску - Страница 15

Просмотреть онлайн или скачать pdf Примечание к выпуску для Переключатель Cisco 9124 - mds multilayer fabric switch. Cisco 9124 - mds multilayer fabric switch 22 страницы. Mds 9000 series
Также для Cisco 9124 - mds multilayer fabric switch: Технические характеристики (2 страниц), Информационный лист (9 страниц), Технические характеристики (3 страниц), Руководство по конфигурации (49 страниц), Примечание к выпуску (48 страниц), Примечание к выпуску (44 страниц), Примечание к выпуску (36 страниц), Примечание к выпуску (3 страниц), Примечание к выпуску (40 страниц), Руководство (16 страниц), Руководство по установке оборудования (36 страниц)

FC AND FCIP WRITE ACCELERATION FEATURE MUST NOT BE

ENABLED WHEN IMPLEMENTING CONTINUOUS ACCESS

ENTERPRISE VIRTUAL ARRAY

Continuous Access Enterprise Virtual Array includes an FC/FCIP write acceleration feature. For

this reason, Cisco's FC and FCIP write acceleration must not be enabled in a Continuous Access

EVA environment. By default Cisco SAN-OS write acceleration is disabled.

FCIP TAPE ACCELERATION

SAN-OS FCIP Tape Acceleration (Write & Read) is disabled by default. Enabling FCIP Tape

Acceleration may cause a tape library to go offline with certain tape backup applications that

support shared tape library options. If this issue is encountered, disable the feature.

Note: FCIP Tape Read Acceleration can only be enabled when both ends of the FCIP tunnel are

running SAN-OS 3.0(1) or newer

SWITCH SETTINGS FOR HP CONTINUOUS ACCESS

ENTERPRISE VIRTUAL ARRAYS AND HP DATA REPLICATION

MANAGER FOR MODULAR ARRAYS

The default load balancing policy for SAN-OS is Src-ID/Dst-ID/OX-ID. This must be changed

when using Enterprise Virtual Array families or Modular Array families configured for

Continuous Access EVA and/or Data Replication Manager (DRM). Change the default load

balance setting to Src-ID/Dst-ID using either one of the following two procedures:

Note: The MDS 9020 only supports Src-ID/Dst-ID.

Using the Management Console or Telnet to Change the Load Balancing Setting

Use the following procedure to change the load balance setting to Src-ID/Dst-ID with

management console or telnet:

Note: Your login account must have network-admin privileges to complete this procedure.

1. Log into the switch using either the management console or telnet.

2. Enter your network-admin privileged account by entering your login name and password.

switch login: admin

Password: <admin password>

3. Enter the following to enter configuration mode:

MDS Multilayer Director & Multilayer Fabric Switches Release Notes