Cisco C3850-NM-4-1G Installation - Page 7
Parcourez en ligne ou téléchargez le pdf Installation pour {nom_de_la_catégorie} Cisco C3850-NM-4-1G. Cisco C3850-NM-4-1G 17 pages.
Également pour Cisco C3850-NM-4-1G : Manuel (15 pages)
Imprimer la page
Installing a Network Module
Installing a Network Module in the Switch
Safety Warnings
This section includes the installation cautions and warnings. Translations of the safety warnings appear in the
Regulatory Compliance and Safety Information for the Catalyst 3850 Switches on Cisco.com:
www.cisco.com/go/cat3850_hw
Read this section before you install a network module.
Proper ESD protection is required whenever you handle equipment. Installation and maintenance personnel
Caution
should be properly grounded by grounding straps to eliminate the risk of ESD damage to the equipment.
Equipment is subject to ESD damage whenever you remove it.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Warning
Do not reach into a vacant slot or chassis while you install or remove a module. Exposed circuitry could
constitute an energy hazard. Statement 206
Equipment That You Need
• Ratcheting torque screwdriver with a number-2 Phillips head that exerts up to 15 pound-force inches
• Panduit crimping tool with optional controlled-cycle mechanism (model CT-720, CT-920, CT-920CH,
• Wire-stripping tools.
• 12-gauge copper ground wire (insulated or not) for the single-hole ground connection.
• 8-gauge copper ground wire (insulated or not) for the dual-hole ground connection.
• Dual-hole ground lug and two screws (included in the DC power supply accessory kit) and single-hole
• Four leads of 14-gauge copper wire.
• Four fork-type terminals from the DC power supply accessory kit. The terminals must be the proper
OL-26779-05
.
(lbf-in.) of pressure.
CT-930, or CT-940CH).
ground lug and screw (included in the switch accessory kit). The dual-hole lug is required for the
grounding of the switch in a NEBS installation where the DC supply is the only NEBS compliant power
supply option.
size for M3 screws in a Dinkle DT-35-B25-style terminal block.
Installing a Network Module in the Switch
Catalyst 3850 Switch Hardware Installation Guide
http://
7