Cisco C3850-NM-4-1G 설치 - 페이지 7

{카테고리_이름} Cisco C3850-NM-4-1G에 대한 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco C3850-NM-4-1G 17 페이지.
Cisco C3850-NM-4-1G에 대해서도 마찬가지입니다: 매뉴얼 (15 페이지)

Installing a Network Module

Installing a Network Module in the Switch

This section includes the installation cautions and warnings. Translations of the safety warnings appear in the

Regulatory Compliance and Safety Information for the Catalyst 3850 Switches on Cisco.com:

www.cisco.com/go/cat3850_hw

Read this section before you install a network module.

Proper ESD protection is required whenever you handle equipment. Installation and maintenance personnel

Caution

should be properly grounded by grounding straps to eliminate the risk of ESD damage to the equipment.

Equipment is subject to ESD damage whenever you remove it.

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Warning

Statement 1030

Warning

Do not reach into a vacant slot or chassis while you install or remove a module. Exposed circuitry could

constitute an energy hazard. Statement 206

Equipment That You Need

• Ratcheting torque screwdriver with a number-2 Phillips head that exerts up to 15 pound-force inches

• Panduit crimping tool with optional controlled-cycle mechanism (model CT-720, CT-920, CT-920CH,

• Wire-stripping tools.

• 12-gauge copper ground wire (insulated or not) for the single-hole ground connection.

• 8-gauge copper ground wire (insulated or not) for the dual-hole ground connection.

• Dual-hole ground lug and two screws (included in the DC power supply accessory kit) and single-hole

• Four leads of 14-gauge copper wire.

• Four fork-type terminals from the DC power supply accessory kit. The terminals must be the proper

OL-26779-05

(lbf-in.) of pressure.

CT-930, or CT-940CH).

ground lug and screw (included in the switch accessory kit). The dual-hole lug is required for the

grounding of the switch in a NEBS installation where the DC supply is the only NEBS compliant power

supply option.

size for M3 screws in a Dinkle DT-35-B25-style terminal block.

Installing a Network Module in the Switch

Catalyst 3850 Switch Hardware Installation Guide

http://