DIGISYSTEM DSC-103SD Manuel d'instruction
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} DIGISYSTEM DSC-103SD. DIGISYSTEM DSC-103SD 3 pages. Digital micro centrifuge
Imprimer la page
Instruction Manual for Digital Micro Centrifuge DSC-103SD with rotor MAR-24
Warnings:
* Do not open the lid before the centrifuge stops completely.
* Do not remove the centrifuge during operation.
* Do not put objects on the top of the lid.
* Do not disassemble the centrifuge by yourself. In the event of a malfunction, the centrifuge should be
repaired by a qualified technician. Before repairing, turn off the power.
Steps:
1. Place the centrifuge on a flat surface. Plug the centrifuge into a properly grounded outlet. Turn on the
power switch. The power indicator on the switch is illuminated.
2. Push the button
screen shows icon "door".
3. Use your two fingers to hold the "Rotor cover head" as shown in" Figure 1" and use
your thumb to press down on the center of "Rotor cover head", and then lift the
cover. Set an even number of test tubes into the rotor in a symmetrical position.
4. Put down and press down the lid. Make sure the lid is closed well. The icon "door"
will disappear on the screen.
5. Push the button
DIGISYSTEM LABORATORY INSTRUMENTS INC.
, and then the screen is illuminated. Press the button
, the speed value is flash one the screen. Push the button
Lid
Power switch
Control panel
www.digisystemlab.com
Emergency bar
Rotor MAR-24
to open the lid. The
or
Figure 1
Rotor cover head
for Rotor MAR-24
or
REV.2-2022