DIGISYSTEM DSC-103SD 사용 설명서

{카테고리_이름} DIGISYSTEM DSC-103SD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGISYSTEM DSC-103SD 3 페이지. Digital micro centrifuge

Instruction Manual for Digital Micro Centrifuge DSC-103SD with rotor MAR-24

Warnings:

* Do not open the lid before the centrifuge stops completely.

* Do not remove the centrifuge during operation.

* Do not put objects on the top of the lid.

* Do not disassemble the centrifuge by yourself. In the event of a malfunction, the centrifuge should be

repaired by a qualified technician. Before repairing, turn off the power.

Steps:

1. Place the centrifuge on a flat surface. Plug the centrifuge into a properly grounded outlet. Turn on the

power switch. The power indicator on the switch is illuminated.

2. Push the button

screen shows icon "door".

3. Use your two fingers to hold the "Rotor cover head" as shown in" Figure 1" and use

your thumb to press down on the center of "Rotor cover head", and then lift the

cover. Set an even number of test tubes into the rotor in a symmetrical position.

4. Put down and press down the lid. Make sure the lid is closed well. The icon "door"

will disappear on the screen.

5. Push the button

DIGISYSTEM LABORATORY INSTRUMENTS INC.

, and then the screen is illuminated. Press the button

, the speed value is flash one the screen. Push the button

Lid

Power switch

Control panel

www.digisystemlab.com

Emergency bar

Rotor MAR-24

to open the lid. The

Figure 1

Rotor cover head

for Rotor MAR-24

REV.2-2022