DIGISYSTEM DSC-103SD 사용 설명서 - 페이지 2

{카테고리_이름} DIGISYSTEM DSC-103SD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGISYSTEM DSC-103SD 3 페이지. Digital micro centrifuge

to set the speed value. Push the button

When you setting the RPM value, you can monitor the RCF value on the RCF/TIME display screen.

6. Push the button

to set the time value. Push the button

7. After setting parameters, push the button

the button

remaining time or RCF value on the RCF/TIME display screen.

8. Push the button

immediately. The centrifuge will run to the current speed setting value.

9. Under the conditions of power failure or the open function failure, please insert the "Emergency Bar"

into the hole at right hand side of centrifuge to force the lid open.

Maintenance and care:

1. Keep the centrifuge clean all the time. Cleaning can be done with a damp cloth. Avoid the use of

solvents as they may damage the product housing, rotor.

2. Check if the rotor is in the center. In case, the rotor is slanted. Stop using machine and contact the

distributor for repair.

Circuit Diagram:

DIGISYSTEM LABORATORY INSTRUMENTS INC.

, the time value is flash on the screen. Push the button

to stop the centrifuge. During operation, you can push the button

to start the centrifuge directly. Release the button and the centrifuge will stop

or any other function button to enter the speed value.

or any other function button to enter the time value.

to start the centrifuge. During operation, you can push

www.digisystemlab.com

to switch the

REV.2-2022