Sharp CD-DH790NH Manuel d'utilisation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Sharp CD-DH790NH. Sharp CD-DH790NH 34 pages. Mini component system

Imprimer la page

System connections

Make sure to unplug the AC power lead before making any connections.
AM loop aerial
Installing the AM loop
aerial
< Assembling >
< Attaching to the wall >
wall
screws
(not supplied)
FM aerial
Right speaker
Wall socket (AC 220 - 240 V ~ 50/60 Hz)
■ Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and
position the FM aerial wire in the direction where the
strongest signal can be received.
External FM aerial:
Use an external FM aerial (75 ohms coaxial cable) for
better reception. When an external FM aerial is used,
disconnect the supplied FM aerial wire.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM and GND terminals.
Position the AM loop aerial for optimum reception. Place
the AM loop aerial on a shelf, etc., or attach it to a stand or
a wall with screws (not supplied).
Note:
Placing the aerial on the unit or near the AC power lead
may cause noise pickup. Place the aerial away from the
unit for better reception.
■ Speaker connection
● Connect the black wire to the
minus (–) terminal, and the red
wire to the plus (+) terminal.
● Use speakers with an
impedance of 4 ohms or more,
as lower impedance speakers
can damage the unit.
● Do not mistake the right and
the left channels. The right
speaker is the one on the right
side when you face the unit.
● Do not let the bare speaker
wires touch each other.
● Do not allow any objects to fall into or to be placed in
the bass reflex ducts.
● Do not stand or sit on the speakers. You may be
injured.
■ Demonstration mode
● The first time the unit is plugged in, the unit will enter
● To cancel the demonstration mode, press the DEMO
● To return to the demonstration mode, press the DEMO
■ Connecting iPod to a TV
The iPod with photo and video can be viewed by
connecting to a TV/monitor.
If the TV/monitor has a video input, connect it to the VIDEO
OUT socket on the rear of the unit.
Note:
Please make sure to set iPod unit to either NTSC or PAL
to match your TV signal. Please visit Apple's homepage for
further information.
■ AC power connection
After checking all the connections have been made
correctly, plug the AC power lead of this unit into the wall
socket If you plug in the unit first, the unit will enter the
stand-by mode.
Note:
Unplug the AC power lead from the wall socket if the unit
Incorrect
will not be in use for a prolonged period of time.
E-5
input socket
the demonstration mode. You will see words scroll.
button (remote control) during power stand-by mode.
The unit will enter the low power consumption mode.
button again.
TV
To video
Video cable
(not supplied)
Left
speaker
Red
Black