Crestron 4 Series Manuel de démarrage rapide - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Crestron 4 Series. Crestron 4 Series 8 pages. Control processor for zūm lighting control system
Également pour Crestron 4 Series : Manuel de démarrage rapide (8 pages), Manuel de démarrage rapide (6 pages), Manuel de démarrage rapide (6 pages), Démarrage rapide (5 pages), Manuel de démarrage rapide (6 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (2 pages), Pour commencer (2 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (12 pages)

Imprimer la page
Crestron 4 Series Manuel de démarrage rapide
MC4/MC4-I
Observe the following when connecting the control system:
The control system is powered over PoE (Power over Ethernet) via a
l
Crestron PoE injector (PWE-4803RU) or a Crestron PoE switch
(CEN-SW-POE-5 or CEN-SWPOE-16). All PoE equipment is sold
separately.
The included cables may not be extended.
l
Mount the included antenna per the guidelines described in
l
Antenna.
Connect the chassis ground lug to a known earth ground circuit (such
l
as building steel) to ensure that the control system is grounded
properly.
Apply power after all connections have been made.
l

Mount the Antenna

The included antenna should be placed in a location that maximizes signal
strength and limits impedance. Refer to the Best Practices for Installation
and Setup of Crestron RF Products (Doc. 6689) at
www.crestron.com/manuals.
If installing the control system in a rack enclosure, the antenna should be
mounted outside of the enclosure using the Crestron ANT-EXT-10 (sold
separately). For more information, refer to the ANT-EXT-10 Installation
Guide (Doc. 7047) at www.crestron.com/manuals.

Configure the Device

The control system may be configured using the provided web
configuration interface. The interface can be accessed using the control
system IP address or the Crestron XiO Cloud™ service.
Mount the
Configuration via IP Address
To access the web configuration interface using the control system
IP address:
NOTE: The control system ships with DHCP enabled. A DHCP server is
required to access the web configuration interface via the device
IP address.
1. Connect the control system to the network.
2. Use the Device Discovery tool in Crestron Toolbox™ software to
discover the control system and its IP address on the network.
3. Enter the control system IP address into a web browser.
Quick Start
4