Bittree 422A32 Manuel de l'utilisateur - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Bittree 422A32. Bittree 422A32 15 pages. Rs-422 64-port active data patchbay
Imprimer la page
Port 1 (Controller)
Green
Yellow
LED
LED
Off
Off
Flashing
Off
Page 11 – Bittree RS-422 64-Port Active Data Patchbay User Guide
Port 2 (Remote)
Green
Yellow
LED
LED
Off
Off
Off
Off
Diagnosis / Possible Causes / Actions
•
Are the Power Indicator LEDs of the patchbay
lit and indicating proper power? If not, the
patchbay is not powered up.
•
Are both the controller and the remote device
turned on, powered up and plugged into the rear
panel DE9 connectors?
•
Is the controller set in "master" mode?
•
The controller may be not be operating correctly.
•
Is the controller successfully controlling the
remote device? If so, the patchbay may be
exhibiting an internal fault. Call Bittree
Customer Service.
•
Is the circuit connected directly to the back of
another active RS-422 Patchbay? The rear
interfaces of two Active RS-422 Patchbays
cannot be directly connected to each other (i.e.,
no tie-lines).
•
Is there is a patchcord connected only to Jack 2?
If so, plug its other side into Jack 1.
•
Is there is a patchcord connected to both Jack 1
and Jack 2? If so, the patchcord may be broken,
or the bantam audio jacks and/or plugs may not
be making good contact. Test the continuity of
the patchcord. Clean the plugs of the patchcord
and try inserting and removing them a few
times. NOTE: Bittree strongly discourages the
use of cleaning sprays or abrasive cleaning tools
on the bantam audio jacks.
•
Is there no patchcord connected to either Jack 1
or Jack 2? If so, the patchbay may be exhibiting
an internal fault. Call Bittree Customer Service.
•
Is the controller successfully controlling the
remote device? If so, the patchbay may be
exhibiting an internal fault. Call Bittree
Customer Service.