Siemens SIMATIC ET 200S Manuel - Page 26

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Siemens SIMATIC ET 200S. Siemens SIMATIC ET 200S 28 pages. Distributed i/o digital electronic module 4do dc24v/2a hf
Également pour Siemens SIMATIC ET 200S : Manuel de l'opérateur (18 pages), Manuel (16 pages), Manuel de l'utilisateur (16 pages), Manuel de l'utilisateur (26 pages), Manuel (37 pages), Manuel (24 pages), Manuel des fonctions (40 pages), Mode d'emploi (4 pages), Mode d'emploi original (19 pages), Mode d'emploi original (20 pages), Manuel (34 pages), Manuel (14 pages), Manuel (24 pages), Mode d'emploi original (17 pages), Mode d'emploi original (19 pages), Manuel (16 pages), Manuel (12 pages), Manuel (32 pages), Manuel (18 pages), Manuel (12 pages), Manuel (28 pages), Manuel (22 pages), Manuel (22 pages), Manuel (36 pages), Manuel (16 pages)

Connecting

5.2 Wiring unused channels of the analog input modules

Sensor selection

Note the following factors when selecting the sensors:

● Length, impedance, and capacitance of the cable

● Reaction speed of the utilized sensors

5.2

Wiring unused channels of the analog input modules

Rules

Pay attention to the following instructions when wiring unused channels:

● "Deactivate" unused input channels when assigning parameters.

● A deactivated channel always returns the value 7FFF

● The cycle time remains unchanged at 250 µs.

5.3

Rules

To prevent interference we recommend the following for analog electronic modules:

● Use shielded wires to the sensors and actuators.

● Lay out the wire shields on the shield connection.

● Connect the shield connection to the ground bus with low impedance.

Note

The permitted limit values can be exceeded (up to <10%) at the measuring inputs of the

electronic module in the event of cable-related HF radiation up to 100 kHz. This is made

necessary by the specified measuring procedure.

2AI I 4WIRE HS analog electronic module (6ES7134-4GB62-0AB0)

Manual, 01/2008, A5E01076124-02