Siemens SIMATIC NET Manuel d'installation - Page 20

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Siemens SIMATIC NET. Siemens SIMATIC NET 34 pages. Network components bus terminal
Également pour Siemens SIMATIC NET : Manuel d'utilisation (29 pages), Manuel d'utilisation (50 pages), Manuel d'utilisation (28 pages), Manuel d'instructions de montage (6 pages), Informations sur le produit (6 pages), Manuel d'installation (40 pages), Manuel d'installation (50 pages), Manuel d'installation (40 pages), Manuel de référence (14 pages), Manuel d'installation (48 pages), Manuel d'utilisation (32 pages)

2.6.2

Connecting DC Power

To connect a low DC power supply to the device, do the following:

Electrical hazard – risk of damage to equipment

Before testing the dielectric strength (HIPOT) in the field, remove the braided

ground cable connected to the surge ground terminal and chassis ground. This cable

connects transient suppression circuitry to chassis ground and must be removed in

order to avoid damage to transient suppression circuitry during testing.

RUGGEDCOM RP100

Installation Manual, 01/2021, C79000-G8976-1011-05

Connect the positive wire from the power source to the positive/live (+/L)

terminal on the terminal block.

Positive/Live (+/L) Terminal

Negative/Neutral (-/N) Terminal

Surge Ground Terminal

Braided Ground Cable

Figure 2.5

Terminal Block Wiring

Connect the negative wire from the power source to the negative/neutral (-/N)

terminal on the terminal block.

Using a braided wire or other appropriate grounding wire, connect the surge

ground terminal to the chassis ground connection. The surge ground terminal

is used as the ground conductor for all surge and transient suppression circuitry

internal to the unit.

Connect the ground terminal on the power source to the chassis ground

terminal on the device. For more information, refer to

(Page

9)".

NOTICE

Installing the Device

2.6.2 Connecting DC Power

"Grounding the Device