3. Make sure Location is set to
Select
Automatic
Select
Network Port
Configurations
then select
AirPort
4. Select
Network Port Configurations
down menu.
5. Under Port Configurations, select
6. Click
. Then close the window.
Apply Now
7. Click the AirPort icon on the menu bar at the top of the Mac
desktop. You see the AirPort status menu:
Choose the ESSID
you assigned to the
projector
8. Check to make sure AirPort is turned on.
9. Select your projector's ESSID.
Note: If you don't need the other network port configurations,
disable them by deselecting their checkboxes.
Now you're ready to connect to the projector. See "Projecting
Over a Network" on page 17.
Using Access Point Mode
To use Access Point (infrastructure) mode, first adjust your
projector and wireless access point or AirPort base station
settings as described in this section.
Configuring the Projector
1. Press the
button, then choose
Menu
.
Enter
2. Choose
Network Configuration
.
Automatic
in the Show pull-
.
AirPort
and press
Network
and press
.
Enter
3. Choose
Wireless LAN
4. Make sure
Advanced
If not, use the
highlight
Advanced
5. If your network is using 802.11a, use the
on the remote control to highlight
to select it.
6. To enable your computer to find the projector on the
network, you need to enter the SSID name of your access
point or AirPort network in the
of your AirPort network may be different from that of your
AirPort base station; select your base station in the AirPort
Admin utility and click
your network.)
Highlight the
ESSID
name. Note that the ESSID is case-sensitive (if you enter the
name in uppercase on the projector, you must type it the
same way on the computer connecting to the projector).
Use the
pointer button to select individual letters; then
press
to input a character. To add a blank space or to
Enter
navigate backward and forward through the input text,
highlight the arrows and press
settings or capital letters, highlight the option and press
. When you're done, highlight
Enter
7. If your access point assigns IP addresses automatically, turn
on
. Otherwise, turn off DHCP and enter the
DHCP
following information:
3/08
PowerLite 1810p/1815p
and press
. You see this screen:
Enter
is selected for the Connection mode.
pointer button on the remote control to
, then press
to select it.
Enter
pointer button
, then press
802.11a
text box. (The name
ESSID
to check the name of
Configure
text box, press
, and enter a
Enter
. To toggle symbol
Enter
and press
Finish
PowerLite 1810p/1815p
Enter
.
Enter
13
-
Imprimer la page