Epson 710C - PowerLite UXGA LCD Projector Spécifications - Page 6
Parcourez en ligne ou téléchargez le pdf Spécifications pour {nom_de_la_catégorie} Epson 710C - PowerLite UXGA LCD Projector. Epson 710C - PowerLite UXGA LCD Projector 8 pages. Epson technical brief for multimedia projectors
Également pour Epson 710C - PowerLite UXGA LCD Projector : Pièces de rechange (1 pages), Fiche technique (2 pages), Supplément au manuel de l'utilisateur (39 pages), Fiche technique (7 pages)
Imprimer la page
EPSON PowerLite 500c/700c/710c Projector
Cleaning the Air Filter
Clean the air filter after every 100 hours of use, or if the
temperature warning light on top of the projector turns
red.
If the filter is not cleaned periodically, it can become clogged
with dust, preventing proper ventilation. This can cause
overheating and damage the projector. Follow these steps to
clean the filter:
1. Turn off the projector and unplug the power cord.
2. Pull up on the filter cover tab to release the cover. You may
need to use a small screwdriver to pry it off.
3. Remove the cover.
The filter is attached to the inside of the cover.
4. To clean the filter, EPSON recommends using a small
vacuum cleaner designed for computers and other office
equipment. If you don't have one, use a dry, lint-free cloth.
5. If the dirt is difficult to remove or if the filter is torn, replace
it. Contact your dealer to obtain a new filter.
6. Snap the filter cover back into place when you're done.
A new air filter is included with the replacement lamp. You
Note:
should replace the filter when you replace the lamp.
Replacing the Lamp
The projection lamp typically lasts for about 2000 hours of
use. It is time to replace the lamp when you see the following:
The projected image gets darker or starts to deteriorate.
The
lamp warning light on top of the projector is either
red or flashing orange.
The message LAMP REPLACE appears on the screen when
the projector lamp comes on.
This happens after about 2000 hours of use. To maintain
projector brightness and image quality, replace the lamp as
soon as possible after you see the message.
EPSON PowerLite 500c/700c/710c Projector
6 -
Warning: Let the lamp cool before replacing it. Also, do not touch
Warning:
Warning:
Warning:
the glass portion of the lamp assembly. Touching the glass portion
of the lamp will result in premature lamp failure.
Contact your dealer or call EPSON Accessories at
(800) 873-7766 in the United States and Canada for a
replacement lamp. Use the following part number when you
order a lamp:
ELPLP10B (PowerLite 700c/500c)
ELPLP10S (PowerLite 710c)
Follow these steps to replace the lamp:
1. Turn off the projector and allow it to cool, then unplug the
power cord.
2. Before removing the lamp, wait approximately one hour
until the projector is fully cooled down.
3. Turn the projector upside-down to access the lamp
compartment.
temperature
warning light
4. Using the screwdriver that came with the replacement lamp,
loosen the lamp cover screw. You won't be able to remove
the screw.
5. Remove the cover. You may need to use a small flat-head
screwdriver to pry it off.
1/00